Support

Jumper Settings

Hard Disk Drives - Older Models

The following jumper information applies to Toshiba's older line of Hard Disk Drives (i.e.models MK-1003MAV, MK-1401MAV, MK-1302MAN, MK-2101MAN): Master configuration is obtained by setting jumper J2 open (no jumper). When J2 is installed, the drive is configured as cable select. If pin 28 = Low, the drive is master. If pin 28 = High, the drive is slave. (Jumper J1 is reserved for factory use only.)

Jumper	P28	Drive
No Jumper	---	Master Drive
J2 Jumper	LOW	Master Drive
J2 Jumper	HIGH	Slave Drive